MENU • Set Up • Searching For Your Code • Blinking Back the Code

How to Program your KID'S CONTROL remote

Set Up

After getting the proper codes from the list below, use the following instructions to enter them into your remote.

Hold down the MUTE key and the ON/OFF key till the LED blinks twice and release
PRESS and RELEASE the Volume Down key(#0)
ENTER the 3 digit code for your brand.
You should receive 2 quick flashes after entering your code.
PRESS the POWER button to test the code.
**To program the TV use the Volume Up key(#9) in the procedure above.

3 Digit Brand Codes

CABLE
SATELLITE
TELEVISION

Searching For Your Code

If you have tried all of the set-up codes for your brand of equipment, or your brand is not listed, and you are still not able to get the unit to respond, try the following procedure to search for your code.

HOLD down the MUTE key and the ON/OFF key until the LED blinks twice and then release both keys.
Now press 9-9-1 (LED will blink twice)
ALTERNATE slowly between the VOLUME DOWN key and the ON/OFF key until your device turns off.
Make sure that the remote is pointed at your device during the search, You may have to press this sequences of buttons up to 100 times to search the entire library of codes.
When your device turns OFF, PRESS the MUTE key to lock in the code for your device.

Blinking Back the Code:

PRESS and HOLD the Mute key and the ON/OFF button until the red LED flashes twice, then RELEASE.
PRESS 9 - 9 - 0 followed by the VOLUME DOWN Key.
PRESS 1, carefully COUNT the number of blinks. (1st digit)
PRESS 2, carefully COUNT the number of blinks. (2nd digit)
PRESS 3, carefully COUNT the number of blinks. (3rd digit)

If the remote DOES NOT blink it means the number is 0.
This is your 3-digit setup code.
**Substitute VOLUME UP when searching for the TV code.

All Material Copyright ® Universal Electronics Inc.
Any questions about the products should be directed to cablehelp@ueic.com